Portable satellite kit
Easy to assemble and disassemble…
And it takes up very little room when stored.
The KIT CARRY SAT was designed expressly to be assembled and reassembled
every time the vehicle is moved, or even every night. The pre-fitted dish has
an LNB boom that can be reclined and a pole fixing bracket divided into two
sections, allowing the entire kit to be stowed in just a few seconds. All Carry
Sat models can be connected to any kind of satellite receiver. Use the FSAT1
or DSF 80 finders to facilitate pointing with the digital receiver.
Digital Satellite precision finders
21
This kit consists of the following:
• Aluminium (TP3 ALU) tripod which is opened and closed like
an umbrella.
• Preassembled 65 or 80 cm dish with tiltable LNB supporting arm
• Low-noise universal LNB
• 10 m cable with connectors
• 3 pegs for locking to the ground
available models:
•
caRRY Sat alU 80
with 80 cm dish
•
caRRY Sat alU 65
with 65 cm dish
• The
tP3alU
model tripod is also available
It is provided with a
rotating top section
for easier dish
tracking.
DSF 80
Finder with 8
satellites and
Signal Level Indicator.
Compatible with all
manual satellite systems.
DSF 80/E
Finder with 8
satellites, Signal
Level Indicator and
Electronic Dish Elevation
Indicator. This model can
only be used on
Voyager Matic
and Voyager Digimatic
systems - equipped with a
special Electronic Angle Detector system.
User’s instructions:
1) Select the required satellite (e.g. ASTRA 19E )
2) Raise the dish to the relevant elevation for the current location
of the vehicle (see the Angle map)
3) Turn the dish SOUTHWARDS until DSF80/E emits a
continuous "BEEP" sound.
4) Wait for the SAT OK diode (LED) to light up, confirming that
the located satellite is the required one.
5) If a different satellite has been found, the SAT NOT OK LED
will light up and the dish must be rotated again until the
"BEEP" sound is heard again and the SAT OK LED lights up.
6) Optimise pointing by slowly adjusting both dish elevation
and dish rotation, until the maximum number of lit LEDs is
obtained on the LEVEL indicator.
